Gee™ Posted June 13, 2007 Report Share Posted June 13, 2007 (edited) Right well ive got a Pro2 hub all nice and dandy, In my hands its fine, but when i put it in the frame, and tighten the bolts up the cog goes really stiff, asin its hard to move it around with your fingers and same with the cranks when you put the chain on, has this happened to anyone else and how do i solve it? I also had this problem with a Hope XC when i started so maybe its just hope's in general, ive completely taken the hub apart and everything is in the right place there is a washer separating both bearings like on the axle ratchet side so no problems there. Any ideas? Edited June 13, 2007 by Roberto_Gazzio Quote Link to comment Share on other sites More sharing options...
basher Posted June 13, 2007 Report Share Posted June 13, 2007 Profiles sometimes have this problem, and i think its because of some really thin washers are missing. Quote Link to comment Share on other sites More sharing options...
AdamR28 Posted June 13, 2007 Report Share Posted June 13, 2007 Have you had it apart?Check the freehub seal has gone back in correctly Quote Link to comment Share on other sites More sharing options...
Gee™ Posted June 13, 2007 Author Report Share Posted June 13, 2007 Have you had it apart?Check the freehub seal has gone back in correctly Leg-EndSorted it, cant beleive how simple it is and how much trouble me and a few friends have had with that. Cheers Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.