streetzguy Posted May 17, 2007 Report Share Posted May 17, 2007 Hi all i was just wondering if you have to buy CNC backings with the pad in or is there another way of getting your pads out of your plastic backing.any help would be appreciate thanks Jack Quote Link to comment Share on other sites More sharing options...
Boswell Posted May 17, 2007 Report Share Posted May 17, 2007 Yes RimJam V3's have CNC backings. RimJam V3's Quote Link to comment Share on other sites More sharing options...
Krisboats Posted May 17, 2007 Report Share Posted May 17, 2007 Yes RimJam V3's have CNC backings. RimJam V3'sGreat post, you really answered his question , i mean, its not like the cnc backings are actually made by heatsink and the rimjam ones are cast like magura cylinders.The cnc backings are available in with both pad material and without it, though having the heatsink material in them for only an extra £4 is a bit of a no brainer decision wise. Pads can be taken out of plastic backings too, by heating up the glue to break its bond between the backing and the pad. Sticking them in the oven seems to be the most effective way of doing this, though be careful not to burn them Quote Link to comment Share on other sites More sharing options...
James Quigley Posted May 18, 2007 Report Share Posted May 18, 2007 As abovePre-heat your oven to 200 degrees.Place pads on a baking tray and leave in over for just 5mins.Remove pads from oven (handle with care) and the material should pop out quite easily.The ninsert material snuggly into Heatsink cnc backings. (dap of superglue if you like) Quote Link to comment Share on other sites More sharing options...
Apocalypse_reaper666 Posted May 18, 2007 Report Share Posted May 18, 2007 Cool and serve with a glass of wine Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.