N Roach Posted January 6, 2007 Report Share Posted January 6, 2007 hey,I have a magura hs33 on the rear, and the hoosing has been put through the holes between the up and dwon tube on my GU frame. I wont the hoosing to sit on the out side of the frame. -Can i just undo the bolt on the lever (The bolt which attaches the hoosing to the lever) and some how stop the fluid from coming out, then take the hoosing out through the frame?or, Is this not possible?cheersnafan Quote Link to comment Share on other sites More sharing options...
PaRtZ Posted January 6, 2007 Report Share Posted January 6, 2007 na even if you did stop it falling out you would have air in the system when you do the bolt back up Quote Link to comment Share on other sites More sharing options...
N Roach Posted January 6, 2007 Author Report Share Posted January 6, 2007 na even if you did stop it falling out you would have air in the system when you do the bolt back upok, cheersNafan Quote Link to comment Share on other sites More sharing options...
XPbIM3 Posted January 6, 2007 Report Share Posted January 6, 2007 i used to unplug housing from lever and plug it again. no air.maybe u will need to drop some additional oil-drops in lever holes to be sure there in no air will be in system Quote Link to comment Share on other sites More sharing options...
steve1rc Posted January 6, 2007 Report Share Posted January 6, 2007 (edited) You could do that and then pump a tiny bit of oil in the slave cylinder almost like a tiny bleed to get rid of the minimal air that might be there. (I think)EDIT: Or do what XPbIM3 said, they're basically the same principal.Steve Edited January 6, 2007 by steve1rc Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.