Dan-Walker Posted August 15, 2006 Report Share Posted August 15, 2006 How do you fit the heatsink refills to the cnc backings, because ive tried and failed. Quote Link to comment Share on other sites More sharing options...
Deonn h Posted August 15, 2006 Report Share Posted August 15, 2006 How can you fail .I used epoxy glue extra strong.It will have some epoxy resin and epoxy hardener in the pack , you can get some from b&q.Then you have to mix them together , then get an old spoon or sumething and scoop it into the backing.Press your pad in and put it in a vise or anything you can find to clamp it together.Then just leave it for however long it says. Quote Link to comment Share on other sites More sharing options...
Janson Posted August 15, 2006 Report Share Posted August 15, 2006 You may have to trim the pads down a little, but it's a no brainer. Also, if you can, clean the pads and backings before gluing. I use paint thinner. Quote Link to comment Share on other sites More sharing options...
Tom Booth Posted August 15, 2006 Report Share Posted August 15, 2006 I use paint thinner.Good for removing tar on rims too Quote Link to comment Share on other sites More sharing options...
Matthew_Gibson Posted August 15, 2006 Report Share Posted August 15, 2006 When I had the CNC backing, I had a pair of blues, they when in really easy, so glue was needed. I also had reds, they needed a push in, juts get then in so they don't fall out and put them in a vice, nip the vice in. No glue needed! Quote Link to comment Share on other sites More sharing options...
Dan-Walker Posted August 15, 2006 Author Report Share Posted August 15, 2006 I was being too much of a pussy, sooo, i got a hammer to em' ...... all sorted now. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.