Mr Motivator Posted July 12, 2006 Report Share Posted July 12, 2006 My park tool crank puller has managed to strip the threads on both cranks on both sets of burns I have. This isn't helpfull.How can I get the feckers off?I was thinking something along the lines of using a steering wheel puller. Or something that grabs around the back of the crank arm, rather than in the thread.Hmmn? Quote Link to comment Share on other sites More sharing options...
Caleb Posted July 12, 2006 Report Share Posted July 12, 2006 hammer it from both sides until they come off Quote Link to comment Share on other sites More sharing options...
Mr Motivator Posted July 12, 2006 Author Report Share Posted July 12, 2006 Isis says no.Tried it. Lots. Quote Link to comment Share on other sites More sharing options...
Lawnmowerman Posted July 12, 2006 Report Share Posted July 12, 2006 Boiling water and a rubber mallet. Quote Link to comment Share on other sites More sharing options...
Mr Motivator Posted July 12, 2006 Author Report Share Posted July 12, 2006 Tried that too. Quote Link to comment Share on other sites More sharing options...
Lawnmowerman Posted July 12, 2006 Report Share Posted July 12, 2006 Try harder. It will work. Quote Link to comment Share on other sites More sharing options...
Mark W Posted July 12, 2006 Report Share Posted July 12, 2006 Didn't for me. I just rode my bike sans crank bolts, and checked them after every few moves just to see if they were loose. When they got a tiny bit of a wiggle on, I finished the job with a hammer. The next time though, I just angle ground them off Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.