Jump to content

Back Cowm Quary


Recommended Posts

From where?

lol

M62! towards leeds ( u will have to go M56 Manchester then M6 preston then M62 leeds

So, M62 junction off for Rochsale (i think its junction 19 ish)

u get off there, go down the short dual carrisge way to the major lights with a BnQ on the left, turn into the left filter lane to go left.

Under the Co-Op bridge then Right around the round about until u done a 90 right (3rd exit)

U then go down that dual carridge way for about 1 mile until u get to a round about, Try to pre empt this as u will need to turn left so try n get into the Left lane.

After turning left, u go for about 4-5 miles, over a few round abouts and through so country side for a bit. U will pass a Co-Op (Small one) on your right which is slightly up a hill, about 10meters up a road. Its just before a Zebra crossing.

WHen u have that on your right, turn left.

Down that road about 300 Yards is a Cross roads, DONT FORGET TO STOP!

Simply carry on up the hill, past the resivoiur and u will simply get to the gates of the place!

ALL from memory :S:S:S

Link to comment
Share on other sites

If you manage to get to Bacup look for a street called tongue lane, it is near a zebra crossing on the main street, and as said above go up the massive hill past the big lake and your at the gates.

Link to comment
Share on other sites

sit in the hard shoulder of the m62 and wait for a car with a trials bike on the back to come past, then floor it and follow them there, lol. never fails even if they aint goin there you will end up at some kind of trial. lol.

rob

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...