Hope Mini Leaver...

[Nick Dale]

Ok so i have ordered a new adjuster screw because mine is buggered and i have no idea on how to change it :)

When i 1st looked at it i thought the leaver would just come out like on a magura but at another glance i saw a cir-clip in there :)

I don't know how to get the leaver away from the body so i can't change it :(

How do i go about this problem?

Thanks,

Nick.

[Danny]

Is it a screw with a ball on the end like the C2? If so you will have to take the circlip off then the brass washer which means your piston will come flying out meaning you will have to rebleed it :)

Edit:

Yep you do as shown here.

[The Next Steve Peat]

Its not too bad.

1st you remover the lever blade.

then remove the rubbery thin

then the thin silver circlip

then you need some inward stretching circlpi plires to remove the next circlp. Do this slowly other wise the piston might pop out too far.

then pull the brass barrel and the brass washer out.

then put it all back together which is the hard bit because you need to put the brass barrel, the brass washer and the circlip in together whilst pushing the piston back.

[Nick Dale]

Poop,

Is there no way of doing it without having to re-bleed?:)

Thanks so far,

Nick.