gee Posted January 11, 2012 Report Share Posted January 11, 2012 I would like to run a peg on a front pro 2 and wondered if this was the best way about it. remove QR adapter cone on both sides from , drill them to 10mm, and replace. buy m10 around 130mm in length ensuring only the last 10-15mm is threaded. push bolt through hub, cones should sit snug on bolt because only end is threaded. put back on bike with peg installed. any better ways around it? i know i could buy hub with solid axle but would like to use pro 2. Quote Link to comment Share on other sites More sharing options...
sstein Posted January 11, 2012 Report Share Posted January 11, 2012 pro 2s can use an m10 female axle system. just use that Quote Link to comment Share on other sites More sharing options...
monkeyseemonkeydo Posted January 11, 2012 Report Share Posted January 11, 2012 pro 2s can use an m10 female axle system. just use that I can see a 9mm conversion and a 15mm conversion but not a proper M10 compatible version. Quote Link to comment Share on other sites More sharing options...
gee Posted January 11, 2012 Author Report Share Posted January 11, 2012 pro 2s can use an m10 female axle system. just use that only on the rear hub not front Quote Link to comment Share on other sites More sharing options...
sstein Posted January 11, 2012 Report Share Posted January 11, 2012 sorry missed the bit about it being a front Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.