dann2707 Posted May 19, 2011 Report Share Posted May 19, 2011 (edited) Hey. So after doing a re-bleed on my HS33 this is the result of how far the pistons move on the slave cylinders. Looks like it's barely moving!? Is this because of a shit bleed? Or is there anyway to maximise their travel. The TPA is all the way out and that blah. Here is a pic that Ive just taken after the bleed, the lever is pulled all the way thanks to moma bear whilst I took the pic. I think its about time I found a rear disk.... Edited May 19, 2011 by dann2707 1 Quote Link to comment Share on other sites More sharing options...
SamKidney Posted May 19, 2011 Report Share Posted May 19, 2011 Did you make sure that the lever cylinder was all the way down against the tpa pin? Quote Link to comment Share on other sites More sharing options...
dann2707 Posted May 19, 2011 Author Report Share Posted May 19, 2011 yeah. 1 Quote Link to comment Share on other sites More sharing options...
SamKidney Posted May 19, 2011 Report Share Posted May 19, 2011 Id give it another bleed, just to make sure, whack it on the bike and see how it feels mate. Quote Link to comment Share on other sites More sharing options...
LukasMcNeal Posted May 19, 2011 Report Share Posted May 19, 2011 Make sure the tpa is all the way out when bleeding then bleed again Quote Link to comment Share on other sites More sharing options...
dann2707 Posted May 19, 2011 Author Report Share Posted May 19, 2011 It was mate. 1 Quote Link to comment Share on other sites More sharing options...
LukasMcNeal Posted May 19, 2011 Report Share Posted May 19, 2011 Check the lever piston isn't stiff, push it down when there is no fluid in and then bleed and it should move up obviously! If not might be that sticking a bit Quote Link to comment Share on other sites More sharing options...
Nyczek Posted May 20, 2011 Report Share Posted May 20, 2011 Due try these... Press the lever with minimum piston move and watch when slave cylinder's piston move too. If it isn't an the same time. Rebleed the break. ATAH lukas have right too But IMHO you have air in lever, so you need only to move out air from there Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.