315r Posted October 31, 2009 Report Share Posted October 31, 2009 Hello, I have noticed that my coust pads are not very flat.Now I have mounted other new and flat coust, but the other ones are still with a lot of stuff.I'm thinking to make flat again and mount again, but i don't know how can i do this.Some advice, idea?Thank you. Quote Link to comment Share on other sites More sharing options...
totaltrials Posted October 31, 2009 Report Share Posted October 31, 2009 Stick your pads in a vice.Get an angle grinder and grind the high spot off till it's level with the low spot.Then draw file the pad with a rough file until it it's flat and smooth. Search for this if you don't understand. Quote Link to comment Share on other sites More sharing options...
duncan_echo26 Posted October 31, 2009 Report Share Posted October 31, 2009 You could also use a sharp stanley knife to cut the pad so it is almost flat and the sand it till it's perfectly flat.That worked well for me. Quote Link to comment Share on other sites More sharing options...
315r Posted October 31, 2009 Author Report Share Posted October 31, 2009 I will use a angle grinder or similar..Because I have been trying to do with a cutter and it's very difficult to do a straight cut and i have been near to destroy mi pads..Thank you. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.