ConnorPowell Posted October 8, 2007 Report Share Posted October 8, 2007 Well im having problems with my canecreek c2 headset, the problem is that it is costentantly loose and knocking back a forth. i seem to think that i have something missing, or that im not putting it together right, so has anyone got a diagram that shows the correct way it goes and all of the bits needed please. Thanks connor Quote Link to comment Share on other sites More sharing options...
Ash-Kennard Posted October 8, 2007 Report Share Posted October 8, 2007 is your top cap sitting on the top of your forks? that one f**ked me over Quote Link to comment Share on other sites More sharing options...
Broomer Posted October 8, 2007 Report Share Posted October 8, 2007 lower crown race? the bit that sits tightly on the forks is that on? Quote Link to comment Share on other sites More sharing options...
ConnorPowell Posted October 8, 2007 Author Report Share Posted October 8, 2007 The top of my steerer tube is no where near touching my top cap. Quote Link to comment Share on other sites More sharing options...
anzo Posted October 8, 2007 Report Share Posted October 8, 2007 Is it tightening up and then being loose as you ride? Or loose straight away?As they're cartridge bearings, you should only have the bottom cup, top cup and the cap to sit on the stem...If I remember rightly? As ash said, make sure the top of your fork steer tube isnt reaching the stem cap, otherwise it's impossible to tighten up...and so you'll have to cut your steer tube down a bit.Do you not have a 'C' shaped ring with the headset? I know with the hope on you have a ring that sits into the top bearing and stablises the tube from movement... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.