Jump to content

Should I Shouldn't I


bakewell

Recommended Posts

This is an awesome frame, mine only lasted a year, but took one hell of a beating. lovely to ride, but i had loads of trouble witht he 116 spacing they had ont he production frames. But with the 135 spacing can get a pro2 and it would be mint.

Link to comment
Share on other sites

well i went from being very sketchy and not bevy good, to being at the stage im at now, which is alright. but that frame is lovely, the only reason it cracked is cause the stays were so mangled. I had managed to put several huge dents in the down tube and so so so many dents in the stays, but finally cracked just behind the CNCed BB yoke.

Trying to finish of a vid of me changing from my 247 to my Adamant, but you get a nice close up of the damage and cracks.

But for £350 it is the nicest bike you will ride, really is recommended!!!

Edited by Orgun_Donor
Link to comment
Share on other sites

good to hear it can take a beating then. i'm just getting back into it after a few years off. use to ride a orange zero till i snapped the forks on a hop and broke my teeth which i never want to go through again

Link to comment
Share on other sites

The Hubs are 24Seven, practically the same as Deng hubs but my rear one i had a few problems with(again 116 not the 135), also make sure you get a better gear ration, mine came with 18:12, and is just silly hard, try and get 18:15 or 18:16.

The cranks are tensile copies basically, but i wouldnt recommend putting a front freewheel off them, my ENO didnt fir properly(unless you run without a bash).

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...