jamesrs250

yeah,,,but on the onza headset the ring was tight around the fork tube..on the new head set the ring was not tight

yeah will leave it like it is at the moment. then when i get better on the bike ill change that..i did not even notice new head set so i must of put it together wrong

to end up front wheel what does that mean lol

what does FFW mean :$

i started with a onza t bird but could not get the bb out so i bought a monty frame so what i have got is monty frame mission front wheel onza forks h11 Hydraulic Brakes onza rear wheel the first thing im going to change are the onza forks because they are quit heavy and i think because they are the older ones they are a bit small and wobble in the tubing to finish the bike i just need to get a crank and pedal

would it be better to buy a new head set

stanard onza off a t-bird

thanks but they dont sell them in 1/8 size

yeah the bearings not the hole headset they look like these http://cgi.ebay.co.uk/Campagnolo-headset-bearings-3-16-nos-/330455112415?cmd=ViewItem&pt=UK_sportsleisure_cycling_bikeparts_SR&hash=item4cf0a8dadf#ht_500wt_947

only ones i can find there are echo ones will the fit

i have a onza t bird and i need the bearings what i have drawn arrows two. i dont know what thay are called or where to get them from does any one know .. they are like a ring with about 15 ball bearing in,,,,,thanks

it proper hard metal the hack saw hardly marks it lol.may have to try and hit it out

best picture i could get

its not the same metal the frame is made of im not sure if its the shell from the bb still in there

i would say a 20" is better for a beginner,,,mission reefer 26" not a bad bike though i like them

i have now drilled this out now but does the part in the picture come out what i have draw red

if you getting the bike for a good price than yeah..but then if not you might as well get some think a bit cheaper as your first bike will get alot of bashing

i was thinking that a bike shop would say to get a new frame. becuse the paint work is not that good so make the frame look like its now worth doing,, i just dont want to waste a good frame, re taped the threads is not a problem i can do that

yeah i know the left side is normal thread and the right (drive) side is reverse thread ill give that a go. if that dont work its going to got to the bike shop

i would start on a 20inch they are a bit easyer to jump and hop on to start with

hi im james from gillingham kent, i have not rode a bike for about 4 years since passing my driving test. so im staring to ride agen just bought a onza t-bird to start with

i cant get my bottem bracket out both sides have the teeth worn down i have tried mole grips and puting the bike in a vice but still will not come out,,,,, any ides

thanks very much

thaks that was quik,,,what side is drive side the one with the sproket

i have just bought a onza and need to replace the bottom bracket what way does it un-do lefty loose and righty tight or is it the over way round thanks james